Download Application Note - Bound-T time and stack analyser

Transcript
ADSP-21020 registers, instructions, or other
features
Decoding
Control flow
Definition
Arithmetic
Table 8: Synopsis of ADSP-21020 Support
R0 .. R15: fixed point,
+
+
+
+
+
+
+
+ Equivalent to zero.
Index registers I0 .. I15, except bit-reverse
+
+
+
+
M0 .. M15
+
+
+
+ The C Calling Protocol requires some
M and L registers to hold constants.
+
+
+
+
Condition codes: EQ, LT, LE, AC, NE, GE, GT, NOT AC
+
+
+
+
NOP and IDLE instructions
+
+
+
+ The idling time is not considered.
+
+
+
Index register I0 .. I7 bit-reverse operations
+
+
+
F0 .. F15, floating
point, all operations
+
+
+
Condition codes other than the above
+
+
+
The use of circular buffers
+
+
+
Reading (via Universal Register address):
PC, PCSTK, PCSTKP
FADDR, DADDR, LADDR
CURLCNTR, LCNTR
+
+
+
System registers read or written via Universal
Register address, or modified by system-register bitmanipulation:
MODE1 (not alternate register bits), MODE2
ASTAT (see above for flags)
STKY, IRPTL, IMASK, PMWAIT, DMWAIT
+
+
+
Alternate (secondary) registers as controlled by
MODE1 bits.
Memory access with index register I0 in bit-reversed
mode as controlled by MODE1 bit BR0.
+
+
Assignment (via Universal Register address) to:
PCSTK, PCSTKP,
LADDR, CURLCNTR, LCNTR.
Push or pop of loop stack or status stack.
+
R0 .. R15: XOR
addition, subtraction
when both operands are the same
Remarks
register
L0 .. L15
B0 .. B15
ASTAT
flags AZ, AN, AC
R0 .. R15, fixed point: multiplication,
shift, average
AND, OR, NOT, CLIP
XOR
for two different registers
Instructions for later SHARC processors
26
Supported ADSP-21020 features
If the operation sets a flag to a
constant (usually zero), then the flag
is supported for arithmetic, too.
Instructions that store values in
PMWAIT and DMWAIT have no effect on
the number of memory wait states
assumed for instruction timing; that
assumption is set by the commandline options -xxx_ws .
An assignment to MODE1 will
generate a warning message.
The possible effect on control-flow is
not modelled. A warning message is
generated.
Only ADSP-21020 instructions are
supported and decoded. Other
instructions lead to error messages.
Bound-T for ADSP-21020