Download Lab Exercise
Transcript
Time Required Approximately one hour Lab Preparation It is highly recommended that the student read through this entire procedure once before actually using it as a tutorial. It is also recommended that the tutorial software was run first to preload compiler options and source files as well as to load many of the main.c files. Equipment and Materials It is assumed that the student has already completed prior labs and the software is installed properly. Software needed Quantity Install the tutorial framework from the autoinstaller located at 1 http://cosmiac.org/thrust-areas/academic-programs-and-designservices/education-and-workforce-development/community-portal/ . The designer will also want Putty or similar RS-232 terminal program for viewing the UART output. Hardware needed Quantity The hardware required is the TI Tiva LaunchPad Kit and the Digilent Orbit board 1 Additional References The Evaluation Board user’s manual is on this web site: http://datasheet.octopart.com/EK-TM4C123GXLTexas-Instruments-datasheet-15542121.pdf and the manuals for the Digilent orbit board are located at http://digilentinc.com/Products/Detail.cfm?NavPath=2,396,1181&Prod=ORBIT-BOOSTER. Here is the datasheet for the temperature sensor http://ww1.microchip.com/downloads/en/DeviceDoc/21935a.pdf . Here is the place to find and download putty www.putty.org. COSMIAC tutorials found at: http://cosmiac.org/thrust-areas/academic-programs-and-designservices/education-and-workforce-development/microcontrollers/ate-developed-material/ 2