Download Manual - Martindale Electric

Transcript
Martindale ET4000 / ET4500
Instrument description
4 Instrument operation
4.1 Batteries and charging
The instrument uses six AA size alkaline or rechargeable Ni-MH batteries. The nominal
operating time specified is for batteries with a nominal capacity of 2100 mAh. The
battery condition is always displayed in the lower right corner of the display. If the
batteries are too weak the instrument indicates this as shown in Figure 4.1. This
indication appears for a few seconds and then the instrument turns itself off.
Figure 4.4.1: Discharged battery indication
The batteries are charged whenever the battery charging adapter is connected to the
instrument. The charging adapter socket polarity is shown in Figure 4.2. Internal
circuitry controls the charging and assures maximum battery lifetime.
-
+
Figure 4.4.2: Power supply socket polarity
Symbols:
Indication of battery charging
Figure 4.4.3: Charging indication
Warnings related to safety:

When connected to an installation, the instrument's battery compartment can
contain hazardous voltages! When replacing batteries or before opening the
battery compartment cover, always disconnect any test leads or measuring
accessories and turn off the instrument.

Ensure that the batteries are inserted correctly, otherwise the instrument will not
operate and the batteries could become discharged.

Do not recharge alkaline battery cells.

Use only the PSUPD230 battery charging adapter supplied with the instrument.
Notes:

The charger in the instrument is a pack cell charger. This means that the battery
cells are connected in series during charging. The batteries have to be similar
(same charge condition, same type and age).

If the instrument is not to be used for a long period of time, remove all batteries
from the battery compartment.
15