Download FXCPU Structured Programming Manual
Transcript
FXCPU Structured Programming Manual [Device & Common] Error code 5 Errors 5.2 FX1S/FX1N/FX1NC/FX2N/FX2NC PLCs PLC operation at error occurrence Contents of error Action Operation error [M8067(D8067)] 6742 The measured value variation exceeds the limit. (ΔPV < -32768 or 32767 < ΔPV) 6743 The deviation exceeds the limit. (EV < -32768 or 32767 < EV) 6744 The integral result exceeds the limit. (Outside the range from -32768 to 32767) 6745 The derivative value exceeds the limit due to the derivative gain (KD) beyond the limit. 6746 The derivative result exceeds the limit. (Outside the range from -32768 to 32767) 6747 The PID operation result exceeds the limit. (Outside the range from -32768 to 32767) <The PLC continues PID operation.> The PLC continues operation with each parameter set to the maximum or minimum value. <Step response method> The auto tuning result is improper. <The PLC finishes auto tuning, and starts PID operation.> • When auto tuning was finished, the difference between the measured value at the start of auto tuning and the target value was 150 or less. • When auto tuning was finished, the difference between the measured value at the start of auto tuning and the target value was 1/3 or more. Check the measured value and target value, and then execute tuning again. <Step response method> Auto tuning operation direction mismatch <The PLC forcibly finishes auto tuning, and does not start PID operation.> The operation direction estimated from the measured value at the start of auto tuning did not agree with the actual operation direction caused by the output for auto tuning. Correct the relationship among the target value, output value for auto tuning and measured value, and then execute auto tuning again. 6752 <Step response method> The auto tuning operation is improper. <The PLC finishes auto tuning, and does not start PID operation.> The PLC did not execute auto tuning correctly because the set value fluctuated during auto tuning. Set the sampling time to a value sufficiently longer than the output change cycle, or set the input filter constant to a larger value. After changing the setting, execute auto tuning again. 6760 Sum check error in the ABS data sent from the servo Check the connection to the servo and parameter setting. 6750 6751 262 Continues operation