Download "user manual"

Transcript
5. Universal Serial Communications
5.
5-5
Universal Serial Communications
• A general purpose computer or an ASCII unit of the PLC (master station) controls the POD (slave
station) using dedicated commands.
Dedicated commands
Read
General-purpose computer
POD
disc
SYSTEM
F1
F2
Write
F3
F4
F5
CN1
RESET
F6
F7
POWER
Interrupt
RS-232C or RS-422 (RS-485)
• For 1 : 1 connection, the POD can send an interrupt to the master station through switch
activation, write command from the keypad, and screen change.
• Use CN1 of the POD for connection with a general-purpose computer. Either signal level
RS-232C or RS-422 (RS-485) can be selected.
• In addition to 1 : 1 connection, 1 : n connection is available between the general-purpose
computer and the POD via RS-422.
(A maximum of 32 PODs can be connected.)
For 1 : n connection, interrupts cannot be used.
General-purpose computer
RS-422 (RS-485) connection
CN1
POWER
POD No. 1
CN1
CN1
CN1
SYSTEM
SYSTEM
SYSTEM
SYSTEM
F1
F1
F1
F1
F2
F2
F2
F2
F3
F3
F3
F3
F4
F4
F4
F4
F5
F5
F5
F6
F6
F6
F7
F7
F7
POWER
POD No. 2
POWER
POD No. 3
F5
F6
F7
POWER
POD No. “n” (n = 1 to 32)
• For more information, refer to the User’s Manual <PLC Connection> (FEH380).
5
Connections
• The POD internal user memory addresses ($u) must be used for memory allocation for switch,
lamp or data display parts.
When the master station specifies a screen number, data is written to the internal memory address
($u) allocated for the screen. If the screen is switched internally, the new screen number is read
and is written to the internal memory address ($u) allocated for the screen.