Download motion_instr.
Transcript
Motion Move Instructions 3-63 between these two and is used to drive the motor to make the actual position equal to the command position. The Figure below shows the relationship of these three positions. + Command Position Position Error – Actual Position Figure 3.20 Position Relationship See the Motion Axis Object specification for a more detailed overview of the Nested Digital Servo Loop used by the ControlLogix motion controllers. To successfully execute a MRP instruction, the targeted axis must be configured as either a Servo or Feedback Only axis. Otherwise, the instruction errs. IMPORTANT The MRP instruction execution may take multiple scans to execute due to the fact that it requires transmission of multiple messages to the motion module. Thus, the Done (.DN) bit is not set immediately, but only after these messages have been successfully transmitted. This is a transitional instruction: • In relay ladder, toggle the rung-condition-in from cleared to set each time the instruction should execute. • In structured text, condition the instruction so that it only executes on a transition. See Appendix C. Arithmetic Status Flags: not affected Fault Conditions: none Publication 1756-RM007G-EN-P - May 2005
Related documents
Local PDF
Local PDF
ControlLogix Motion Module Overview
Motion Coordinate System User Manual
Motion-RM002 - Rockwell Automation
LOGIX-UM001A-EN-P, PhaseManager User Manual
Introduction
AXIS_SERVO_DRIVE
Logix Controller Motion Instruction Set
1756-RN017 - Rockwell Automation
1394 Drive Conversions Technical Data
Firmware Release Notes DriveLogix5720 Controller (12.20)