Download Modems - high

Transcript
Uncoded
M&C Interface
Input/Output Impedance
External Reference Input
Form C Relays
BPSK, QPSK/OQPSK
EIA-232, EIA-485 (2- or 4-wire),
Ethernet 10/100BaseT (Dependent on
operational mode)
CDM-570 & CDM-570-IP: Matched for 50/75Ω,
BNC connector
CDM-570L & CDM-570L-IP: Transmit and
Receive 50Ω, female Type N connector
1, 2, 5, 10 or 20 MHz, BNC connector
Tx, Rx traffic alarms and Unit faults
Acquisition Range
± 1 to ± 32 kHz,
1 kHz step
± 1 to ± 32 kHz,
1 kHz step, Symbol Rate <=
625 ksps
±1 to ± 200 kHz,
1 kHz step, Symbol Rate >
625 ksps
Highly dependent on data rate, FEC rate, and
demodulator acquisition range. Examples:
120 ms average at 64 kbps, Rate 1/2 QPSK, ±10 kHz
acquisition sweep range, 6dB Eb/No
3.5 s average at 9.6 kbps, R1/2 QPSK,
±10 kHz, 6dB Eb/No
512, 1024, 2048, 4096, 8182, or 16384 bits
Buffer Disabled (Rx Satellite), Buffer Enabled
(Symmetric or Asymmetric Operation) (data interface
dependent)
± 100 ppm minimum
Eb/No, Frequency Offset, BER, Buffer fill status, Rx
signal level
Acquisition Time
MODULATOR
Frequency Stability
Output Power
Accuracy
Phase Noise
Output Spectrum/
Filtering
Harmonics and Spurious
Transmit On/Off Ratio
External Tx Carrier Off
Tx Clock Options
CDM-570 &
CDM-570L &
CDM-570-IP
CDM-570L-IP
±1 ppm, 0º to 50ºC (32º ±0.06 ppm, 0º to 50ºC
to 122ºF)
(32º to 122ºF)
0 to –25 dBm, 0.1 dB
0 to –40 dBm, 0.1 dB
steps
steps
± 0.5 dB over frequency ± 1.0 dB over frequency
and temperature
and temperature
< 0.75 degrees RMS
< 1.2 degrees RMS
double-sided,
double-sided,
100 Hz to 1 MHz
100 Hz to 1 MHz
Meets IESS-308/-309 power spectral mask
< -55 dBc/4 kHz
(Typically < -60 dBc/4 kHz)
55 dB minimum
By TTL LOW signal, or RTS
Internal (SCT), External (TT), Loop timing with
Symmetric or Asymmetric operation (Data interface
dependent)
DEMODULATOR
Input Power
Range
Max Composite
Level
10-8
(8-PSK)
10-6
10-8
(8-QAM)
10-6
10-8
16-QAM
10-6
10-7
10-8
CDM-570 &
CDM-570-IP
-30 to -60 dBm
+35 dBc, up to
-5 dBm absolute max.
3.3 (2.8)
3/4
6.2 (5.8)
6.8 (6.3)
3/4
6.5 (6.1)
7.2 (6.8)
3/4
7.4 (7.0)
7.8 (7.3)
8.2 (7.7)
CDM-570L &
CDM-570L-IP
-130 + 10 Log Symbol Rate,
dBm (minimum)
-90 + 10 Log Symbol Rate,
dBm (maximum)
+40 dBc, up to
-10 dBm absolute max.
4.4 (4.0) 4.5 (4.2)
6.9 (6.5)
7/8
0.95
7.0 (6.6)
9.3 (8.9)
7.2 (6.8)
10.3 (9.9)
7/8
0.95
6.6 (6.2)
9.6 (9.2)
6.8 (6.4)
10.6(10.2)
7/8
8.1 (7.7)
8.2 (7.8)
8.3 (7.9)
Note: Data Rate and Range specifications on this page reflect CDM-570/L
modem operating in non-Vipersat mode
Receive Buffer
Receive Clock
Options
Clock Tracking
Monitor Functions
Example BER Performance
For symbol rates up to 2.5 Msps (See User’s Manual for higher symbol rates).
Guaranteed Eb/No, in dB (typical values in parentheses) with two adjacent
carriers 7 dB higher
(See the User’s Manual for a complete listing of the performance of all FEC
types, code rates, and modulation types.)
Viterbi
(BPSK, QPSK/OQPSK)
10-5
10-7
LNB Voltage
3/4
6.8 (6.3)
8.2 (7.7)
7/8
7.7 (7.2)
9.0 (8.6)
Viterbi & Concatenated Reed-Solomon 220/200 or 200/180
(BPSK, QPSK/OQPSK)
1/2
3/4
7/8
10-5
4.3 (4.0) 5.6 (4.7) 6.5 (6.0)
10-7
4.5 (4.2) 6.0 (5.2) 6.9 (6.5)
Turbo Product Codec
BPSK
10-6
10-7
10-8
(QPSK/OQPSK)
10-6
LNB Reference
5/16
21/44
2.4 (2.1)
2.8 (2.5)
2.6 (2.3)
3.1 (2.8)
2.7 (2.4)
3.3 (2.9)
21/44
3/4
7/8
2.9 (2.6)
3.8 (3.4) 4.3 (4.0)
10 MHz via Rx center conductor,
-3 dBm ± 3 dB
BLOCK UP CONVERTER (BUC) SUPPORT
(CDM-570L & CDM-570L-IP Only)
BUC Voltage
BUC Reference
FSK Support
Power Supply
0.95
6.4 (6.0)
24 VDC, 90 W @ 50°C, 100 W @ 30°C (internally
fitted option)
48 VDC, 150 W @ 50°C, 180 W @ 30°C (internally
fitted option)
10 MHz via Tx center conductor,
0 dBm ± 3 dB
Via Tx center conductor with FSK BUCs
ENVIRONMENTAL AND PHYSICAL
Temperature
LOW-NOISE BLOCK CONVERTER (LNB) SUPPORT (CDM-570L
& CDM-570L-IP Only)
1/2
5.4 (4.9)
6.7 (6.2)
Operating: 0 to 50ºC (32 to 122ºF)
Storage: -25 to 85ºC (-13 to 185ºF)
100 to 240 VAC, 50/60 Hz
+13, +18, and +24 VDC @ 500 mA maximum
www.high-net.com