Download Manual Name

Transcript
Manual – Prologger Hardware Model 7001D
8.2
Hardware Register Information
The hardware register information can be viewed in Test Mode or used by
programmers wishing to write their own unload and analysis programs. The table
below gives a description of each register numbered 0 to 255. For multiple byte
registers the convention used is . least significant byte to most significant byte. A byte
may contain a number from 0 to 255 (8 bits) and for calculating multiple byte numbers
the first byte is added to the second byte times 256 plus the third byte times 256 times
256, etc.
eg. The four byte number 1234 would give:
1+(2*256)+(3*256*256)+(4*256*256*256) = 67305985
Arithmetic instructions using 32-bit unsigned integers can represent values from 0 to
4294967295.
8.2.1
Prologger Memory Assignments
The Prologger operating the standard instruction set, has the following fixed memory
assignments in the Hardware Register:
(Pin xx) refers to a pin of the INPUT SIGNALS connector.
Address
Size
Description
0
1
Software Revision Number (33 onwards)
1
2
logger runtime in milliseconds (16 bit integer)
3
1
Error flags (see Appendix A)
4
4
logger scan counter (32 bit integer)
8
3
Reserved
11
2
MSB of address (bits 8-23) used in LDBLK and MVBLK
instructions
13
2
Reserved
14
2
Binary states of analog channels
16
8
Eight analog channels (a0 to a7) unsigned low resolution
representation (8 bit) of the 16 bit channel (A0 to A7)
measurement
24
8
Counter channels
Unidata Manual - 7001D Prologger Hardware Issue 4.1.docx
Page 31