Download Installation - Troys Fence
Transcript
Connecting Accessory Devices 7DEOH8VHU3URJUDPPDEOH8VHU5HOD\V)XQFWLRQ2SWLRQV&RQWLQXHG No. Name 13 Loitering Alert Indicates a vehicle is loitering on the Outside Obstruction Loop. Adjustable from 0 delay to 135 seconds delay in 30-second time intervals. Note: LT - LOITERING ALERT adjustments can be made in the Installer Menu. 14 Gate nearing full travel output Activated when the gate is three feet from full travel in both the open and close directions. This output is used to reduce the sensitivity of a proximity sensor near the ends of gate travel. 15 Gate Failure output Activated to report occurrence of a problem. Indicates the system is in an Error Mode, Fault Mode or Entrapment Mode. If active, the gate is disabled. 16 Motor Running output Active when the motor is running and the gate is in motion. 17 AC Power Failure output This relay is normally energized and drops with loss of AC power. 18 DC Power Failure output Activated when the battery power is very low, but the output ceases when the battery is dead. The relay is triggered when the battery is less than 20 Volts. 19 Flasher Relay Controls flashing lights that pulse once per second. The relay is constantly activating except when the open limit switch is triggered. 20 Free Exit Loop Vehicle Detector output Active whenever the Exit Loop is tripped. 21 Inside Obstruction Vehicle Detector output Activated when the Inside Obstruction Vehicle Detector is tripped. 22 Center Loop Detector output Activated when the center loop detector is tripped. Since this input is not used for a sliding gate, User Relay 22 can be used in combination with a detector to perform the function of an arming loop detector because there is no associated gate control logic. 23 External Latching Gate Lock Output Not used in the Smart DC Controller 24 Gate at Partial Open Position Active when the partial open position is reached or exceeded. 4-12 Description SlideSmart Installation and Reference Manual Revision C