Download LPP Operating Manual

Transcript
PMP 25
Portal modules · Pneumatic· Gantry axis
Stop slide/intermediate stop
Bellow
 Air connection
 Minimum distance between the intermediate stops, ZA
The “Bellow” option increases the degree of protection against penetrating materials. The variable dimensions are calculated as follows:
By assembling AS and ZA, several intermediate positions can be achieved. For the
AS 25-1 stop slide, the intermediate position can only be approached from one
side. For the AS 25-2 stop slide, the intermediate position can be approached from
both sides. It is also possible to attach two stop slides to the main slide. This allows
intermediate positions to be set in distances if 1 mm or less. The first intermediate
position at least 30 mm before the end position.
Formulas for calculation of variable dimensions:
FZ = nominal stroke x 0.0288 [rounded off to the nearest whole number]
FBB = FZ x 3.3 [rounded off to the nearest whole number]
Lges = 370 + nominal stroke + 2 x FBB
A = 185 + FBB
Designation
AS 25-1
AS 25-2
Sample calculation; nominal stroke, 500 mm:
FZ = 500 mm x 0.0288 = 14.4 => FZ = 15 [rounded off to the nearest whole number]
FBB = 15 x 3.3 = 49.5 => FBB = 50 [rounded off to the nearest whole number]
Lges = 370 + 500 mm + 2 x 50 => Lges = 970 mm
A = 185 + 50 => A = 235 mm
A
6
57
B
57
57
Number of shock absorbers
1
2
Cable track KSH, horizontal slide
Cable track KSV, vertical slide
Figure: Attachment variant 1
Other attachment variants are possible as standard. Please contact us for assistance.
Figure: Attachment variant 1
Other attachment variants are possible as standard. Please contact us for assistance.
You can find further information and components for the accessories mentioned here in the “Accessories” part of the catalog.
126
www.schunk.com