Download TIMER S4 - Alge

Transcript
TIMER S4
Page 45
Printer P4:
Pb
Pr
Pb-
0.58.862
0.58.871
0.009
run time of the blue course
run time of the red course
blue course wins with a lead of 0.009 seconds
Display board GAZc:
It shows the time in 1/100 seconds on the display board. The 1/1000 seconds are shown on the
display board, when the thumb wheel switch is on position 13 and the shift switch on middle
position. This adjustments must be made on the display board. To show the 1/1000 seconds you
need a board with 6 digits.
With the toggle switch (5) you can select the different times:
A-timer
=
run time of red course
B-timer
=
run time of blue course
C-timer
=
finish-difference time with identification
Data channel 1 (running time):
Data channel 2 (run time):
It shows the running time that is selected with toggle switch (5).
It is not possible to switch to the run time (data channel 2 is not
possible).
Using three display boards:
If you want to show each time on a separate display board you have to output the date with a address
through interface "display board" (14). On page 18 it tells you how you activate the address.
run time of red course
run time of blue course
finish-difference time
thumb wheel switch of display board on position 1
thumb wheel switch of display board on position 2
thumb wheel switch of display board on position 3
Computer output through RS 232 interface:
The interface form the Timer S4 to a computer is the socket RS 232 (15). Interfacing a computer
with a Timer S4 is very easy. Please consult your ALGE agent for information for cables and
software.
Transfer format: 4800 baud, 1 start bit, 8 ASCII-bit, no parity-bit, 1 stop bit
Data format:
####xPRxxHH:MM:SS.zht(CR)
#### ..................... continuous ID number (4-digits)
PR ........................ identification for course
PR .............. red course
PB ............. blue course
HH:MM:SS.zht ..... run time in hours, minutes, seconds and thousandths
x ........................... blank
(CR) ..................... carriage return
Connection for external devices (10, 11, 12 and 13):
-
banana socket (19) for start impulse
socket A (10) for impulse from red course
socket B (11) for impulse from blue course
Version: E-06-04-18
Page 45