Download Proteus Tutorials - MindPlace Support

Transcript
2
A segment is the basic organizational unit of the session. It can be run for one
second or many minutes, and is bounded by the light/sound pulse rates and
brightness levels at the beginning and at the end of the segment. For example,
suppose you have constructed a twenty second segment with the following
parameters:
Red light pulse rate starts at 7.83 hz and ends at 40.0 hz;
Red light brightness starts at 2 (low brightness) and ends at 15 (maximum
brightness);
Green light pulse rate starts at 40.0 hz and ends at 7.83 hz;
Green light brightness starts at 7 (middle brightness) and ends at 7.
[Note: the red channel is called “LFO 1” and the green one “LFO 2”; this is because
you can use other color combinations with Proteus, such as red + blue.]
The Proteus software automatically calculates all of the values in between the starting
and ending values as a linear ramp.
Segment Parameters. Each segment can have a variety of other parameters
assigned to it:
Sound Pitch. Use this to tune the audio waveform. Frequency range is from
40.0 to 600.0 hz, and it can smoothly ramp from one pitch to another during the
segment.
Time. Use this to control how long the segment will run for.
Light Frames and Sound Active checkboxes. These control whether the sound
and light are active during the selected segment.
Soft On and Soft Off checkboxes. Determines whether the currently selected
segment will run through a “soft on” or “soft off” phase; this can be set independently
for both light(frames) and sound. You cannot include both soft on and soft off in a
single segment.
Bin. Beat. Check this box if you want the selected segment to include binaural
beats. This works best when the audio waveform is a sine wave; this is Sound Table
1 if you are using the tables which were preloaded into Proteus at the factory.
Dual LFOs. Check this box if you want to assign different pulse rates to the
two color channels. If you leave this unchecked, Proteus will automatically assign
Channel 1 frequency information to channel 2. However, you will still be able to
control Channel 1 and 2 brightness information independently. Leave this box