Download DPM680

Transcript
BEFORE YOU BEGIN
Please read this instruction manual thoroughly before
installation, operation and maintenance of the DPM680
power meter.
The symbol on the left is used throughout this instruction
manual to alert the user or personnel of the danger or to prompt
caution during the installation and maintenance process.
EMC COMPLIANCE
This power meter has been tested and found to comply with the limits of the IEC/EN61000 EMC
standards. These standards are designed to provide reasonable protection against interference
when using this device. Failure to install or use the device in accordance with the instruction may
cause harmful inteference. This does not, however, guarantee that inteference will not occur in any
installation. In case of inteference, the user is encouraged to:
• relocate or reorient the victim/emitting equipment
• change the connection point of the victim/emitting equipment
• increase the distance between the victim/emitting equipment and the power meter
Please consult a qualified technician for assistance.
DISCLAIMER
Mikro shall not be liable for errors contained herein including any incidental and/or consequential
damages arising from the use of this material. Mikro also reserves the right to vary the product from
that described in this material without prior notice.
COPYRIGHT
The licensed software contained in the product is proprietary software owned by Mikro or its third party
suppliers and it shall be used solely in connection with the product.
1. INTRODUCTION 5
1.1 How to use this Manual 5
1.2 Content of Box 7
1.3 Parts of the Power Meter
7
2. INSTALLATION 9
2.1 Precautions 9
2.2 Meter Placement & Connections 9
2.3 Meter Setup
13
2.4 TCP/IP Connection Setup
14
3. METER OPERATIONS16
3.1 OVERVIEW page & MAIN MENU 16
3.2 Password Authentication
17
3.3 VOLTAGE sub-menu
18
3.3.1
Phase Voltage
19
3.3.2 Line Voltage 19
3.3.3 Peak Voltage 20
3.3.4 Voltage Waveform 20
3.3.5 Voltage Harmonics 21
3.3.6
Sequence Voltages
22
3.4 CURRENT sub-menu
3.4.1 Phase Current 3.4.2 Peak Current 3.4.3
Current Waveform
3.4.4
Current Harmonics
3.4.5 Sequence Currents 3.4.6 Demand Current 3.4.7 Max Demand Current
3.5 PF & FREQUENCY sub-menu 3.5.1 Power Factor (PF) 3.5.2
Displacement PF
3.5.3 PF & Frequency
3.6 POWER sub-menu 3.6.1
Active Power
3.6.2
Reactive Power
3.6.3
Apparent Power
3.6.4
Total Power
3.6.5
Demand Power
3.6.6
Max Demand
23
24
24
25
26
27
27
29
30
31
31
32
33
33
34
35
35
36
37
Table of content
This power meter should NOT be installed or used for primary
protection. Do not use the device in applications where its failure
can cause harm or death. Avoid high fire risk applications.
TABLE OF CONTENT
3