Download SUNSET E10_manual

Transcript
Control Field
LAP-D defines three types of frames, each with a different
control field format. Information transfer frames (I-frames) carry the
data to be transmitted for the user. Additionally, flow and error
control data, using the go-back-N ARQ (Automatic Repeat Request) mechanism, are piggybacked on an information frame.
Supervisory frames (S-frames) provide the ARQ mechanism when
piggybacking is not used. Unnumbered frames (U-frames) provide
supplemental link control functions and are also used to support
unacknowledged operation.
All of the control field formats contain the poll/final bit (P/F). In
command frames, it is referred to as the P bit, and is set to 1 to
solicit (poll) a response frame from the peer LAP-D entity. In
response frames, it is referred to as the F bit, and is set to 1 to
indicate the response frame transmitted as a result of a soliciting
command.
Information Field
The information field is present only in I-frames and some
unnumbered frames. In the case of both control signalling and
packet information, maximum length is 260 octets.
The information field contains the message type and parameters. For example, the SETUP message is used to set up a call.
It contains the bearer capability, originating and destination addresses, transit network selection and other pertinent data.
Layer 3 information is used for intra, as well as interexchange
calls using SS#7.
1.5 DASS2 Technology
Digital Access Signalling System 2 (DASS2) is a common
channel signalling system intended for use between the customer’s
equipment (PBX) and an ISDN local exchange. DASS2 is specified
in BTNR 190 (British Telecom). A 2.048 Mbps line connects the
PBXs to the ISDN exchange. This 2.048M, 32 timeslot signal is
divided as follows:
Ch. 6 ISDN
6-5