Download Man Al2000_eng - FF

Transcript
Page 4 - 7
AL 2000 User Guide
06/05/00
Only approved MODEMs should be connected to the telephone network!
Carrierless MODEMs are usually used over short distances (maximum cable length,
15km). Typically a four wire system is used in order to realise a network.
CONTROL
Software
RS-232C
MODEM
Rx
Tx
Fixed Line
Tx
Rx
Tx
Modem
DS 2856
Rx
Modem
DS 2856
5 4 7 2 3
Connection
RS-232C
Numbers
Fixed
Line
8 7 5 3 2
AL 2000
Tx
Modem
DS 2856
5
AL 2000
Rx
5
AL 2000
Carrierless MODEMs can be used for point-to point connection.
MODEMs are usually mains powered. If a battery back-up is required, the MODEM must
be capable of being powered by a battery.
When a MODEM is used, the following definitions should be made in the PLC.
SER1
SER2
SER3
Data Transfer Protocol
Baud Rate
Data format in
terminal mode
R O 213 2 or 4
R O 215 0 or 4
R O 216 0 or 4
R O 214 0,1,2,3 or 4
R O 229 0,1,2,3 or 4
R O 217 0,1,2,3 or 4
R O 210 0 to 4
R O 219 0 to 4
R O 218 0 to 4
See also: REGISTER MEMORIES, OUTPUTS AND VARIABLES.
FF-Automation Oy