Download User`s Manual

Transcript
3. Check and Preparation
(3) When connecting to Air Particle Sensor (ZN-PD□□-S□)
- Air Particle Sensor ZN-PD-S□
1
- LAN Cable (10BASE-T or 100BASE-TX supported, Safety Category 5e or higher)
Note
Before setting the Air Particle Sensor (ZN-PD-S □ ), read the Instruction Sheet
attached to the product.
Use LAN cable to connect a Differential Pressure Station and Air Particle Sensor (ZN-PD
□-S□). In this case, either straight or cross cable usable.
3.3 Assembly
3.3.1 Connecting Differential Pressure Sensor
To use this product, an optional Differential Pressure Sensor Head ZN-DPS1-S is
required.
Click
Insert the Sensor Head into the Sensor Head connector until it clicks.
3.3.2 Connecting alarm output terminals
Use the attached alarm output connector to connect OUT and GND to the loads according
to the output specifications.
Refer to : 2.3.1 Alarm output
3-2