Download Systems Plus™ Programmer/Controller

Transcript
23
Remote Communications
What is it?
The Envirotronics Systems Plus controller has two modes of communication operation. These are the EMULATION
mode, in which the display of the Systems Plus is echoed to a remote terminal or computer, and the COMMAND mode
in which a remote source may send commands to the Systems Plus and it will respond with requested data, status, or an
error if one has occurred.
Communications Setup
To set the default mode of remote communications, first locate the MAIN MENU on the Systems Plus using the menu
map on page 4 of this manual. Then select number 1 followed by enter for the configuration menu. You will be asked
for the level 2 password. (see: Passwords page 32). Enter the password and you will be given the CONFIGURATION
SETUP menu. Then select number 7 followed by enter and you will be given the COMMUNICATIONS SETUP page
shown below.
This is the Communications Setup
screen, for the definition of serial port
parameters and Controller Port Data
Mode.
Setting Emulation / Command mode
(2) Mode allows you to toggle between emulator and command mode as the default mode for the
RS-232 serial port. When you exit this menu with the RIGHT ARROW, the controller will enter
this mode and also save it as its default mode the next time it is turned on. While in Command
Mode, you may send the command “use emulator mode” to enter the emulator mode and while in
the emulator mode you may press “v0” (v zero) at any time to go to the command mode. (see
Remote Command Set page 24)
End of Serial Input Command Delimiter
While in command mode, all characters sent to the controller, via the RS-232 interface, are stored until
the Command Delimiter is received.
(3) Command End Of Line will toggle the Delimiter between 3 possible settings. CR (Carriage
Return), LF (Line Feed), CR/LF (Carriage Return and Line Feed). If you are using a remote
command terminal and the serial configuration is set properly and you do not get a response, be
sure to check that your command terminal and the controller have the same End of Command
Delimiter.