Download this link - Exeter Software

Transcript
26
Typical applications
The batch file given below performs the following operations: the data matrix is
standardized by variables (rows), a matrix of distances between the objects is computed, the
distance matrix is double-centered, the double-centered matrix is then factored and a plot is
made showing the objects in a 3-dimensional space.
" standardize data if in different units
*stand o=data.nts r=sdata.nts
" Compute distances among objects
*simint o=sdata.nts r=dist.nts
" Double-center the distance matrix
*dcenter o=dist.nts r=dcent.nts
" eigenvectors correspond to projections of objects
*eigen o=dcent.nts n=3 r=proj.nts
*output o=proj.nts
" Display -- Note that direction is "col"
*mod3d o=proj.nts d=col
PCOORDA can also be viewed as a distinct ordination method since it can also be
applied to various types of similarity and dissimilarity matrices - or even to experimentally
determined proximity matrices where there is no original “data matrix.” The computational
steps would then be as follows:
" Double-center the matrix
*dcenter o=dist.nts r=dcent.nts
" Extract eigenvectors
*eigen o=dcent.nts n=3 r=proj.nts
" Output eigenvectors = projections
*output o=proj.nts
" Display -- Note that direction is "col"
*mod3d o=proj.nts d=col
Of course, an arbitrary dissimilarity matrix may not be very compatible with a Euclidean
metric. In such cases many of the eigenvalues may be negative. In performing such an
analysis one hopes that such negative eigenvalues are small and can be ignored.
7.5
Nonmetric multidimensional scaling
This method is similar to PCOORDA in that it can be used to represent the relationships
among a set of points in a low dimensional space. The difference is that in non-metric
multidimensional scaling analysis the distances among the points in the final configuration
need only have a monotone relationship to the distances implied by the original data matrix.
This relaxed constraint usually makes it possible to get a much better fit in fewer dimensions
than is possible in PCOORDA.
If possible, one begins with the results of a PCOORDA as an initial configuration since
this usually results in many fewer iterations being necessary in the MDSCALE module.
"
Use PCOORDA to obtain an initial configuration