Download User Manual

Transcript
(to the next page)
Should your printer require servicing, turn it off and unplug it and make inquiries at the outlet
where it was purchased.
Error code
Hardware
Description of error
Hardware error
Turn off the power and then on again. Call for service if the
problem persists.
Retransfer roller overheating
Turn off the power and then on again. Call for service if the
problem persists.
Retransfer roller malfunction
Turn off the power and then on again. Call for service if the
problem persists.
Retransfer roller thermister
malfunction
Turn off the power and then on again. Call for service if the
problem persists.
Bend remedy roller overheating
error
Turn off the power and then on again. Call for service if the
problem persists.
Bend remedy roller malfunction
Turn off the power and then on again. Call for service if the
problem persists.
Bend remedy roller thermister
malfunction
Turn off the power and then on again. Call for service if the
problem persists.
Overcool
The usage environment temperature is too low.
Use at the specified usage environment temperature.
(Call for service if the problem persists.)
Thermal head overheated
Turn off the power and leave the unit for about 10 minutes before
switching on again. (Call for service if the problem persists.)
EEPROM malfunction
Turn off the power and then on again. Call for service if the
problem persists.
MG connection error
Turn off the power and then on again. Call for service if the
problem persists.
MG mechanical error
Turn off the power and then on again. Call for service if the
problem persists.
MG hardware error
Turn off the power and then on again. Call for service if the
problem persists.
MG communication error
Check the I/F cable connected correctly.Turn off the power and
then on again. Call for service if the problem persists.
Connected external device
malfunctioning
Turn off the power and then on again. Call for service if the
problem persists.
External device switch setting error
Turn off the power and then on again. Call for service if the
problem persists.
External retransfer unit jam error
Press the “reset → enter buttons” and remove cards if they are
not discharged. Press the “reset → enter buttons” and call for
service if the problem persists.
External unit communications error
Check the I/F cable connected correctly.Turn off the power and
then on again. Call for service if the problem persists.
External unit2 communications
error
Check the I/F cable connected correctly.Turn off the power and
then on again. Call for service if the problem persists.
Hardware error
Turn off the power and then on again. Call for service if the
problem persists.
B8
TR Overheat
F0
TR Broken
F1
TR Sensor Broken
F2
RR Overheat
F3
RR Broken
F4
RR Sensor Broken
F5
Overcool
F6
Head Overheart
F8
EEPROM Broken
FA
MG Unconnected
A9
MG Mechanical
AB
MG Hardware
AC
MG Communicate
AF
E X T. U n c o n n e c t e d
B9
E X T. S W S e t t i n g
BA
E X T. J a m
BB
E X T. C o m m u n i c a t e
BE
EXT2 Communicate
BF
Hardware
44
Remedy
47