Download Make: AVR Programming

Transcript
Getting Started: Blinking LEDs
MCU
This is the type of AVR chip you’re using. In our case, we’re using an ATmega168,
so it reads atmega168. For a complete list of supported chips, type avr-gcc -target-help and about halfway down you’ll find a list of “Known MCU names.”
F_CPU
This definition tells the compiler what clock speed your chip is running at. If
you don’t have an external clock source, like a crystal, this is either 1,000,000
or 8,000,000 for the ATmega chips—one megahertz or eight megahertz. Getting this right will matter for the timing of serial communication, and anything
else where timing is key.
BAUD
This is the baud rate that you’re going to use for computer-to-AVR serial communications, and 9,600 baud is a good conservative default.
MAIN
This entry is just the name of the program that you’re compiling and flashing
—the code that contains the main() routine. I’ve filled this in for you in the
book’s projects, but if you want to start a new project from scratch but reuse
this makefile, you’ll need to change the MAIN.
LOCAL_SOURCE
Here you have the chance to list any other .c files that your main code section
needs to run. Again, I’ve filled these in for the book’s projects, but I mention it
here in case you’d like to see how to include multiple files in your compilation.
EXTRA_SOURCE_DIR and EXTRA_SOURCE_FILES
This is an option to include code that lives in another directory or folder somewhere on your system. We’ll use this a lot for including my USART.h standard
serial library.
PROGRAMMER_TYPE
The two “programmer” options are for AVRDUDE, along with information
about what chip we’re programming from MCU. Here, you enter the type of flash
programmer that you’re using, and the makefile passes it to AVRDUDE using
the -c option. If you’re using a USBTiny or USBasp, for instance, you enter that
here. If you’re using the Arduino as a flash programmer, enter avrisp.
PROGRAMMER_ARGS
The other “programmer” option is for any of the other necessary AVRDUDE
options. If you’re using a USBTiny or USBasp, you won’t have to enter anything
here; just leave the line blank. If you are using a serial-based programmer, you’ll
need to specify the serial port and baud rate using the -P and -b options,
respectively.
Chapter 2: Programming AVRs
39