Download FlexMotion Software Reference Manual
Transcript
Chapter 6 Trajectory Control Functions — flex_read_dac and flex_read_dac_rtn Using This Function The Read DAC function returns the value of the specified DAC output. When sent to an axis, this function returns the value of the primary DAC mapped to that axis. The signed 16-bit value returned corresponds to the ±10 V full scale range of the DAC. This function is used to monitor the output command from the PID loop. When the DAC output is connected to a torque block servo amplifier, you can use this value to calculate motor torque or to monitor the acceleration and deceleration portions of a trajectory to see how close the control loop is to saturating at its maximum torque limits. When the DAC output is connected to a velocity block servo amplifier, the DAC value read is a direct representation of the instantaneous commanded velocity. FlexMotion Software Reference Manual 6-94 www.natinst.com
Related documents
latest PDF - Read the Docs
BEDIENUNGSANLEITUNG
NI-Motion User Manual - National Instruments
Bronze Manual
Manuals
Omega Speaker Systems High Speed Load Cell Interface Card LCIC-WIM-BEN User's Manual
National Medication Management Plan User Guide
ConTEXt magazine #2 Februari 2003 Page Ranges
FlexMotion-6C Hardware User Manual
nuDrive Accessory User Guide
UMI-7764
nuDrive Accessory - National Instruments