Download SIMPROCESS - computer structures and systems laboratory

Transcript
Call Center Model
By default, the incoming call buffer can contain no more than 10 calls on hold. If 10 callers are
already on hold, the next incoming call will get a busy signal and be dropped. The maximum number of calls the buffer can hold is also a model parameter, the user will be prompted to change the
queue’s capacity each time the model is run.
If a call is on hold for too long (in the buffer) it will hang up (renege). This is done by setting the
Entity system attribute MaxWait. MaxWait determines the amount of time an entity will wait to
obtain a resource. If the resource is not obtained within the specified time, the entity exits the activity without processing. When this occurs the Entity system attribute EndWait is set to TRUE. This
is demonstrated in the Accept Entity expressions of the branch activities Check Queue and
Response. Note: If further processing is required, be sure to reset MaxWait to 0 and EndWait to
FALSE.
This model demonstrates the use of dynamic labels. The labels for Number of calls on hold and
the labels in the column # of Calls are updated by setting a value for the label to monitor. The
labels under the columns Answered, Balked, and Reneged are updated by using the SIMPROCESS expression statement UpdateDynamicLabel. These statements can be found the Accept
Entity expressions of the dispose activities Balked Calls, Reneged Calls, and Completed Calls.
The sample Dashboard Call Status.spd is included in the Demos subdirectory. This Dashboard is assigned to the Call Center model. To view the Dashboard while the Call Center model is
running, select Tools/Remote/Start Local Dashboard Server. Once the Dashboard Server has been
started, start the model. Make sure the animation is turned on. Once the model has been started, the
Dashboard will appear. See Chapter 16 of the SIMPROCESS User’s Manual for a full discussion of
SIMPROCESS Dashboards.
SIMPROCESS Getting Started
68