Download Div 10 - Public Surplus

Transcript
HNTB Corporation
Roadway Signage Upgrades at Bush IA H
PN552/CIP No : A-028 5
Houston, Texas
Terminal and Entrance Sign housings shall contain small weep holes for drainin g
moisture that accumulates in the signs from condensation . Weep holes shall b e
designed to prevent the entrance of insects .
J.
Welding . The sign housing welds shall be ground smooth after welding, and the
entire housing shall be cleaned and de-oxidized after welding, and proseal treated i n
accordance with Mil specification C-5541 . The enclosure shall then be primed wit h
zinc chromate and finished inside and out with two(2) coats of high grade enamel .
The front and sides of the housing shall be matte black for proper viewing, and the
top, bottom and back shall be white for cooling .
All exterior seams shall be continuously welded and each weld shall be unifor m
flow. All welds shall be neatly formed and free of cracks, blow holes, and othe r
irregularities .
Welding on aluminum housings shall be done by the gas metal arc (MIG) or the ga s
tungsten arc (TIG) processes using bare aluminum welding electrodes . The
electrodes shall conform to the requirements of the American Welding Society
(AWS) A5.10 for ER5356 aluminum alloy bare welding electrodes .
K.
Terminal and Entrance Signs shall have lifting eyes or the equivalent for movin g
and mounting signs . VMS housings shall be designed such that the VMS can b e
shipped and temporarily stored without damage or undue stresses prior t o
installation . VMSs shall be provided with a temporary storage support frame tha t
will permit the storage of the VMS in an above-ground vertical position withou t
damage to the sign housing.
2 .03 TERMINAL AND ENTRANCE SIGN CONTROLLER
A.
The Contractor shall install a field sign controller in a base mounted cabinet in fron t
of the sign, as shown in the plans . The sign controller for Terminal and Entranc e
Signs shall be microprocessor based and shall be designed to fit in a standard EI A
19" equipment rack. The sign controller shall reject any transmission that does no t
contain its identifying address . The sign controller shall have the capability t o
display any message transmitted from central or any message stored in the sig n
controller memory .
B.
The sign controller shall have permanent memory in the form of plug-in PRO M
integrated circuits, which shall contain the operating firmware and diagnostic tes t
messages . The controller shall also have changeable memory in the form of RA M
integrated circuits with a lithium battery backup that retains the data in memory fo r
a minimum of one year following a power failure . It shall contain the library o f
messages, the message display schedule and changeable operating parameters . The
VARIABLE MESSAGE SIGN S
10438- 7
3-8-99