Download OccuSwitch DALI User Manual

Transcript
Operating principle
2.1.3.
OccuSwitch DALI BMS
Figure 3: Two cell offices linked to a BMS system
The OccuSwitch DALI BMS is a module that allows connecting a maximum of 64 OccuSwitch DALI devices to a
DALI interface, for example of a BMS system. Each OccuSwitch DALI can be assigned to a maximum of 16
groups.
The BMS system can override the local OccuSwitch DALI control. This allows, for example, to switch all lights
on when specific alarms occur or to keep all lights off during the night. The BMS system can also retrieve
status information from each OccuSwitch DALI device.
Table 6: Connectors in OccuSwitch DALI BMS
Connectors
Not commissioned system
Commissioned system
DALI output connector (DA)
The system regulates all
connected luminaires identically.
This can cause insufficient further
away from the window.
Up to four output groups can be
set. This allows setting correct
light levels for the luminaire
groups.
For commissioning, see Chapter 4.
DALI input connector (X)
Complete standard DALI interface for connecting to any DALI system.
For commissioning, see Chapter 4.
Example
Figure 3 shows an example layout of two cell offices. Each office part has its own OccuSwitch DALI BMS and
two rows of luminaires (a window row and a corridor row). The OccuSwitch DALI devices are connected to a
BMS system. Both OccuSwitch DALI BMS systems control the connected lights automatically. The BMS
system is used to monitor the system and to override the local settings in special situations.
11