Download Poseidon MkVI User Manual
Transcript
Poseidon MkVI User Manual Chapter 1 Page 4 Carbon dioxide absorbent cartridge At the heart of all rebreathers is the requirement to remove the metabolically-generated carbon dioxide (CO2) from the breathing loop and replace the oxygen consumed through metabolism. The Poseidon MkVI is designed around a modular plug-and-play carbon dioxide filter system. It is equipped to handle Molecular Products SofnoDive® 797 axial flow prepacked cartridges. Procedures for changing out the cartridge are presented in detail below in the Cartridge Housing discussion. your partner from a distance. Once the rig is properly turned off following a dive, the smart battery can be removed and taken to a desk-top charging station. Use and maintenance of the smart battery are discussed later in this chapter. Gas injection module In a fully-closed rebreather like the Poseidon MkVI, oxygen is consumed by the diver and a mechanism must be provided for replacement of that used oxygen. Otherwise the mixture will slowly be depleted to dangerously oxygen low levels (hypoxia). The MkVI is designed to maintain the partial pressure of oxygen (PO2) well above hypoxic levels, and to also prevent it from becoming too high (hyperoxia). This is achieved by a control system that uses sensors that are responsive to the partial pressure of oxygen and a mechanism for the addition of pure oxygen to the system when the sensors indicate that the oxygen level is below the target value, known as the PO2 “setpoint”. The gas injection module in the Poseidon MkVI does this and much more. In a patented design, this module provides the mechanisms for not only adding pure oxygen to make up for metabolized gas, but also to automatically calibrate the oxygen sensors prior to diving, as well as validate the sensors during the course of each dive. Electronics module The electronics module provides a single plug-and-play component that includes the previously described gas injection module and the smart battery. It also includes the oxygen sensors, the main computer system and the junction for the cables leading to the display, cylinder pressure gages, and HUD. Two thumb-wheel screws allow for easy removal of the electronics module from the gas processor housing after diving. Smart battery The smart battery (Figure 1-6) is another patent-pending design of the Poseidon MkVI. It is a snap-in power supply that allows operation of the rebreather for up to 30 hours when fully charged. It also contains its own onboard computer, and stores not only your dive log data, but also your decompression status (tissue tensions), keeping track of repetitive dive status. The smart battery communicates with the other system computers via the network, and contains two user feedback systems. The first system consists of two extremely bright red LEDs (one facing up, the other facing backwards) that provide a wide viewing angle; the second is a 2-frequency acoustic speaker that broadcasts a very audible tone through the water. Both systems are primarily designed to convey the safety status of your diving rig to Figure 1-5. E-module with battery inserted.