Download A Variable-Speed Sensorless Drive System for

Transcript
SPRA600
1
Hardware to Demonstrate Sensorless Control of the Switched
Reluctance Motor Using the Texas Instruments TMS320F243 DSP
This section describes the hardware used to demonstrate the sensorless control of a typical
switched reluctance motor (SRM) drive using the Texas Instruments TMS320F243 digital signal
processor (DSP). Research completed in March of 1998 and documented in the Application
Report titled “Developing an SRM Drive System Using the TMS320F240” (literature number
SPRA420) led to a baseline software algorithm for conventional operation of the SRM drive
using a shaft position sensor. Follow-on research completed in August of 1999 extended the
performance range of a specific SRM without a shaft position sensor using a sensorless control
algorithm. Detailed information on the sensorless software control algorithm can be found in
Section 2. Hardware used in this follow-on research was the 3-phase, 12/8 stator-poleconfigured SRM manufactured by Emerson Electric Company, and the digital motor controller
board designed and manufactured by Spectrum Digital Incorporated (www.spectrumdigital.com),
which utilizes the Texas Instruments TMS320F243 DSP. The hardware and software algorithm
as described are intended to be used primarily for potential customer demonstrations and to
serve as examples of extended performance sensorless control of SRM drive systems.
1.1
Demonstration Goals
The basic goals of this research work were to build upon the baseline software algorithm as
described in the application report referenced above and to extend the performance range of the
SRM drive using sensorless control. Performance parameters (listed in Table 1) of the SRM
drive were set to cover a wide range of potential customer applications such as white goods
(washing machine), compressor pumps, and blower fan applications.
Table 1. Performance Parameters of the Demo SRM Drive System
Speed range
Load torque
Speed regulation
150 to 4500 rpm
no load to 48 oz-in
10% over full speed/torque range
In addition to these basic requirements, other goals were to successfully start the SRM from
standstill under a full load torque of 48 oz-in.
1.2
Hardware Description
Hardware used for this demonstration is described in the following sections. A diagram of the
interconnections between the various hardware elements that make up this SRM demonstration
platform is shown in Figure 1.
4
A Variable-Speed Sensorless Drive System for Switched Reluctance Motors