Download GSM-Control User Manual

Transcript
Wonderware Finland & Baltics GSM-Control
5
There are different kinds of USB to serial port adapters available on the market,
as a rule also the corresponding USB/serial driver software is supplied – after
installing the driver, the new virtual COM port (physically using USB port) is
added to the computer; this COM port must be selected in GSM-Control as a COM
port where GSM-modem is connected.
Installing the GSM-Control
The GSM-Control installation package is supplied as a Microsoft Installer file
P067_xxx.msi, where xxx is the current (latest) version of GSM-Control.
To install the GSM-Control, run the P067_xxx.msi and proceed as directed by the
GSM-Control Setup Wizard. The installation is simple and straightforward, only it
is important to select the correct protection (HASP key or software license) in
“Custom Setup” dialog.
The HASP key or software license key is needed for full time running of GSMControl. The HASP key is an USB key (dongle) to be installed into PC USB port
and needs the SafeNet Sentinel LDK Run-time Environment (HASP HL Runtime
Package) to be installed and running – see details in “Licensing by using HASP
HL key” section below. The software license key is a 16-character alphanumeric
“computer-dependent” string, provided after purchasing the GSM-Control (for
more information, see “Software license key” section below. Without HASP key
installed or software license key entered, the GSM-Control will run one hour in
demo mode. After purchasing the GSM-Control, the appropriate HASP key or
software license key is provided and no re-installation of GSM-Control is needed.
In case “HASP Device driver” and “HASP Files” are not selected then HASP
USB key will not be supported and only the software license will be available
(files needed for HASP USB key will not be installed):
GSM-Control User Manual Ver. 4.x Rev 4.5
P067m45.docx