Download View - Onset

Transcript
Tattletale Installation and Operation Manual
ANSI-C
Section 6 - Hardware and Interface Specifications
Power Supply Considerations
NOTICE
The Tattletale can be severely damaged by reversing
the power supply or battery connections. DO NOT
reverse the connections or you will void the warranty.
Before connecting a power supply to the DC power
jack, make sure that the center of the tip is negative and
the sleeve is positive.
Sleeve +
– Tip Center
Correct DC Power Jack Polarity
Power supply or battery connection points are available on the Tattletale (BAT+ is at
pin B1, GND is at pin B11). The IO-8 and PR-8 prototyping boards bring these lines
to a standard DC power jack. The supply voltage should be between 7 and 15 volts.
The Model 8 operates at two levels of VREG. When awake and active, VREG is
maintained at 5 Volts. In low power drain mode, Vreg is maintained at 3.3 Volts. In
order to take full advantage of these two modes, the Model 8 utilizes two voltage
regulators. The LTC1174CS8-5 switching regulator is the relevant regulator in 5V
mode. The 1174 has an absolute maximum input supply voltage rating of 15V which
must not be exceeded! In low power mode, the 1174 is shutdown. In this shutdown
mode, the 1174 draws only 1µA. The LT1121CST-3.3 linear supply, which is always
active, provides VREG in the low power mode. The 1174 will provide up to 340mA in
the 5V mode. The 1121 can provide up to 200mA in the 3.3V mode.
During your initial development you will need a DC power supply with an output in
the range of 7 to 15V that can provide a current of about 300mA. We strongly
recommend a current limited supply. The IO-8 and PR-8 prototyping boards have DC
power jacks on the boards.
When no connector is in the DC power jack, the AUX line is connected to the BAT
line. When a connector is inserted in the jack, it breaks this connection and supplies
power directly to the BAT line. The AUX line is left floating. So, you could have a
battery connected to the AUX line. Then when you insert the plug (from some other
power source), it will disconnect your battery and supply the Tattletale from the other
source. These drawings show how the plug works schematically. Figure 6-3 shows the
jack with nothing plugged in. The AUX and BAT lines are connected at the arrow:
D-3285-C
Onset Computer Corporation - Model 8 with C
Page 6-5