Download Operation & Programming Guide
Transcript
Nanjing Washing CNC System User’Manual MENU Chapter One 31DT System Overview ................................................................................................1 1.1 31DT system indicator...........................................................................................................1 1.1.1 Main specifications .....................................................................................................1 1.1.2 System resource...........................................................................................................1 1.2 Coordinate system provision.................................................................................................1 1.2.1 Movement principles which are relative to stationary work piece .........................1 1.2.2 Standard coordinate system provision ......................................................................2 1.2.3 Provision on machine tool moving component direction.........................................2 1.2.4 Machine tool reference point......................................................................................2 1.2.5 Work piece coordinate system ...................................................................................2 1.2.6 Cutting tool compensation principle when changing cutting tool ..........................3 Chapter Two Programming ................................................................................................................4 2.1 Block format...........................................................................................................................4 2.1.1 Parameter ....................................................................................................................5 2.2 Preparative function (G function) ........................................................................................6 2.2.1 G00-Fast locating .....................................................................................................7 2.2.2 G01-Line interpolation ............................................................................................7 2.2.3 G02—Interpolation of clockwise arc.........................................................................8 2.2.4 G03—Inverse arc interpolation .................................................................................9 2.2.5 G04—Time delay ........................................................................................................9 2.2.6 G09-Feed angle-specified stop.................................................................................9 2.2.7 G20-Sub-program call .............................................................................................9 2.2.8 G22-Sub-program definition .................................................................................10 2.2.9 G24—Completion and returning of sub-program .................................................10 2.2.10 G25-Jump processing........................................................................................... 11 2.2.11 G26-Transition processing (sub-program call in the program)........................ 11 2.2.12 G27—Endless cycle................................................................................................. 11 2.2.13 G30—Magnification and minification cancel.......................................................12 2.2.14 G31-Magnification or minification .....................................................................12 2.2.15 G47-Short line speed auto-transition..................................................................12 2.2.16 G48—Cancel G47. ..................................................................................................12 2.2.17 G53—Cancel zero bias............................................................................................12 2.2.18 G54-Absolute zero bias ........................................................................................12 2.2.19 G55-Increment zero bias......................................................................................13 2.2.20 G56-Current point bias........................................................................................13 2.2.21 G71-Internal (external) diameter cutting compound cycle ..............................14 2.2.22 G72—End surface cutting compound cycle..........................................................15 2.2.23 G73—Sealed contour compound cycle..................................................................16 2.2.24 G74—Returning to reference point (mechanical origin).....................................19 1