Download PC Operation

Transcript
PC Operation
listing printout, the B&lean listing printout will stop, the printer will formfeed, and the complete
OUTPUTS USED TABLE will be printed.
Printing Of Error Messages During Ladder Diagram Listing
If any errors in the printing process are detected by the Printer Interface Unit during printing of a ladder
diagram listing, an error message will be printed and the printing may stop, depending on the type of
error. Table 4-6 lists the error messages and their definitions.
Table 4-6. Ladder Diagram Listing Error Messages and Definitions
ERROR MESSAGE
I
ROW OVER
COLUMN OVER
STACK ERROR (SR)
STACK ERROR (CNT)
STACK OVER
STACK OVER (MCS)
MC ERROR
PROGRAM ERROR
DEFINITION
One rung of lo@ exceeds 16 lines.
More than 13 cmuit elements in line
Clock or Reset line not proved in Shift Register logic.
Reset line not rogrammed ID Counter logic.
Pushdown staJ: using AND STR and OR SIX functions exceeds 8 levels.
Imels of MCS control exceed 8.
MCR functions exceed MCS functions.
Any error not listed in tbis table.
NOTE
When the ROW OVER or COLUMN OVER error messages are printed, the printout of the
ladder diagram will continue. When any other error messages are printed, a PRIN’f STOP
message will be printed, paper will feed and printing will stop.
Printing Of Error Messages During Boolean Listing
If any errors in the printing process are detected by the Printer Interface Unit during printing of a
Boolean program listing, an error message will be printed and the printing may stop, depending on the
type of error. Table 4-7 is the Boolean listing emor messages and their definitions.
Table 4-7. Boolean Listing Error Messages and Definitions
I
I
ERROR MESSAGE
I
mSTRUcTIOti_OPERAND
+++~OR”ff
1
???
1
I
DEFINITION
Not a valid ktruction
IncoHect operand
Cross Reference Printout
When the ladder diagram or Boolean printout of the user program has been completed, the printer will
formfkd, then begin to print a cross reference printout of all outputs. The heading of this printout is,
OUTPUTS USED TABLE. The outputs referenced in the user program (real world oufpufs, internal
relays, shift registers and timers/counters) will have an annotation mark to the right of the reference
number.
The outputs used table will continue printing until all output references have been printed. This printout
cannot be stopped, as can the ladder diagram and Boolean listing printouts.