Download Man Pages - LinuxCNC
Transcript
THCUD(9)
HAL Component
THCUD(9)
NAME
thcud − Torch Height Control Up/Down Input
SYNOPSIS
loadrt thcud
DESCRIPTION
Torch Height Control This THC takes either an up or a down input from a THC
If enabled and torch is on and X + Y velocity is within tolerance of set speed allow the THC to offset the Z
axis as needed to maintain voltage.
If enabled and torch is off and the Z axis is moving up remove any correction at a rate not to exceed the rate
of movement of the Z axis.
If enabled and torch is off and there is no correction pass the Z position and feed back untouched.
If not enabled pass the Z position and feed back untouched.
Typical Physical Connections using a Parallel Port
Parallel Pin 12 <= THC controller Plasma Up
Parallel Pin 13 <= THC controller Plasma Down
Parallel Pin 15 <= Plasma Torch Arc Ok Signal
Parallel Pin 16 => Plasma Torch Start Arc Contacts
HAL Plasma Connections
net torch-up thc.torch-up <= paraport.0.pin-12-in
net torch-down thc.torch-down <= paraport.0.pin-13-in
net torch-on motion.spindle-on => parport.0.pin-16-out (start the arc)
net are-ok thc.arc-ok <= motion.digital-in-00 <= parport.0.pin-15-in (arc ok signal)
HAL Motion Connections
net requested-vel thc.requested-vel <= motion.requested-vel
net current-vel thc.current-vel <= motion.current-vel
Pyvcp Connections In the xml file you need something like:
<pyvcp>
<checkbutton>
<text>"THC Enable"</text>
<halpin>"thc-enable"</halpin>
</checkbutton>
<spinbox>
<width>"5"</width>
<halpin>"vel-tol"</halpin>
<min_>.01</min_>
<max_>1</max_>
<resolution>0.01</resolution>
<initval>0.2</initval>
<format>"1.2f"</format>
<font>("Arial",10)</font>
</spinbox>
</pyvcp>
Connect the Pyvcp pins in the postgui.hal file like this:
LinuxCNC Documentation
2015-12-16
331