Download Mars Manual

Transcript
RandomFibers {
Volume -6 in 6 in -6 in 6 in -0.25 in 0.25 in
Length 5 cm
ElementSize 1 cm
Seed 134
// increase Bending to make fibers more contorted
Bending 0.9
NumberOfFibers 2000
}
}
Twisted Cable
This generation scheme generates straight segments of twisted cable. The input parameters are shown below. The best way to test this generation scheme is to start from
the input below, ake changes to the input and visually display the resulting mesh. In a
twisted cable, individual wires are kept from crossing each other using the edge-edge contact algorithm. The node-edge contact algorithm may be sufficient for some simulations,
saving time but being potentially unreliable.
BeamList CABL {
sec o m STEL r 0.1 in
Generate {
TwistedCable {
Strands 7 // 1, 7, or 19
WiresPerStrand 7 // 1, 7, or 19
WireRadius 0.1 in
CableLength 100. in
ElementLength 2. in
WireRotationPitch 10.
StrandRotationPitch 20.
}
}
}
7.1.2
Select commands
The edge select commands make is possible to select a subset of edges using various
criteria. The selection can be saved in a separate list using the MakeList command or
used on a temporary basis. The standard Select commands are available:
Select [criterion]
AlsoSelect [criterion]
Unselect [criterion]
Reselect [criterion]
InvertSelection
65