Download VisionHDP
Transcript
VisionHDP™ User Manual and Installer Guide Other Commands Freeze frame S/W Rev Video/Film flag Input Reselect TV Black TV Contrast TV MV Black TV MV Contrast In 3,4 sync level MENU MENU MENU MENU MENU MENU MENU MENU MENU 0 0 0 0 0 0 0 0 0 9 9 9 9 9 9 9 9 9 0 0 1 1 3 3 3 3 4 0 3 8 9 6 7 8 9 4 Freeze picture (RS232 code = ‘z’). Any button exits Display software revision, save-count and serial-number Display input type on screen as video (V) or film (F) Ignore reselection of same input TV decoder black TV decoder contrast TV decoder Macrovision black offset TV decoder Macrovision contrast offset Adjust sync-sense level for input 5 or 6 Saving the Configuration Save NOTE: If a save command is not executed, any changes will be lost when the unit is put into standby power mode, or if power is interrupted. Permanently save the current configuration. Note that, once saved, the configuration is retained even if the unit is disconnected from power. Configuration from previous save is retained to allow one-level of save-undo. The command format is: MENU → SAVE → SAVE OK OK Save Undo Revert to the configuration over-written by the last save. Repeating the save undo command toggles between the last two saved configurations. The command format is: MENU → SAVE → UNDO OK OK Revert To Factory Settings Set all parameters to factory defaults. A SAVE is required to make permanent. The command is: MENU 0 9 9 9 Same as MENU → SAVE→ FCTRY OK Restore Configuration Saved during calibration During calibration, the video technician can save the resulting Lumagen configuration to a special hidden configuration memory. This command restores that configuration in the event that the user inadvertently changes the configuration. A SAVE is required to make the restore permanent. The command format is: MENU → SAVE→ RESTORE OK Revert To Defaults For Current Output Resolution Sets output parameters to defaults for the current output resolution. A SAVE is required to make permanent. The command is: MENU 0 9 9 8 © 2004-2007 Lumagen®, Inc. Same as MENU → SAVE→ FCTRY OK 27 Rev 1.14