Download Specification
Transcript
Electrical Installation Electrical Installation Installation Category • Installation category - Installation category II, Pollution degree 2 • Follow National and local electrical codes for installation in a Class 1, Div.2 area. For voltage, frequency and power refer to the appropriate Specification sheet: See “Section 12: Technical Data & Specifications” on page 169. Fuses There is a fuse situated on the DC input version power supply, type 2A time-delay, this can be replaced by the user. Replacement of fuses should be carried out by qualified service personnel. If the fuse should blow again there is probably a problem elsewhere within the unit and the recorder should be returned for inspection to your authorised Honeywell distributor or Honeywell Service department. Cables To fully comply with the requirements of the CE Mark, all cables connected to the rear of the unit should use screened cable terminated at both ends. A low impedance earth cable (<50 mΩ) must be connected to the earthing stud on the rear of the recorder, to ensure that the recorder is always earthed. Before performing any installation please read the section on “Safety” on page 2.and “Warnings and Safety Precautions” on page 3. All connections to the unit are made via the rear panel, the layout of which is shown in Figure 2.3 on page 13 Signal Wiring WARNING ENSURE SAFETY EARTH CONNECTION Always ensure the unit is connected to safety earth when connecting to an AC or DC supply. Failure to comply with these instructions could result in death or serious injury. The Honeywell recorder is intended for panel-mount use, and only the front face is intended to be exposed to the operator. Disconnection from the supply MUST be made possible by means of a switch, circuit breaker or other means of supply isolation. The disconnection device must be included in the panel installation, clearly marked, in close proximity to the Honeywell equipment, and within easy reach of the operator. The protective earth terminal must remain connected (even if the recorder is isolated from the mains supply) if any of the analogue or relay terminals are connected to hazardous voltage. 12 43-TV-25-30 Iss.2 GLO June 06 UK