Download APD 2000 Users Manual

Transcript
APD 2000® Users’ Manual
2.7 GENERAL USE (CONTINUED)
While data logging is enabled, the APD 2000® stores a data entry into its internal memory
whenever an alarm occurs, the radiation rate or cumulative dose changes, the user marks an
event or, if no other significant change in status occurs, every 5 minutes.
The mark an event:
1. Press the EVENT key (6).
2. A two-digit Event number (7) appears on the display for 3 seconds.
The event numbers range from “01” to “99”, and are incremented every time an event is marked.
The event number will roll over from “99” to “01” if necessary. The event number is reset back
to “01” whenever the unit is turned off, or whenever data logging is disabled by selecting the
disable option under LOG MODE menu option.
The data log history can be retrieved or cleared from the APD 2000® internal memory by using
the APD 2000® Datalogger Software (see para 3). While the data log is being retrieved, the
display shows that the unit is currently uploading information. While uploading, the APD
2000® will not be able to detect agents or irritants, change agent modes, mark events, or add
new entries into the APD.
30