Download User manual

Transcript
Curve coefficient
6XSSO\ WHPSHUDWXUH
°C
70
6WHHSHU
FXUYH VORSH
Brantare
kurvlutning
60
50
40
30
10
0
- 10
- 20
- 30
- 40°C
UTETEMPERATUR
2XWGRRU
WHPSHUDWXUH
The slopes of the heating /cooling
curves indicate how many degrees
the supply temperature is to be increased/reduced when the outdoor
temperature drops/increases. A
steeper slope means a higher supply
temperature for heating or a lower
supply temperature for cooling at
a certain outdoor temperature.
The optimum slope depends on the climate conditions in your location, if
the house has radiators or under floor heating and how well insulated the
house is.
The curve is set when the heating installation is installed, but may need
adjusting later. Normally, the curve will not need further adjustment.
Caution
In the event of making fine adjustments of the indoor temperature, the
curve must be offset up or down instead, this is done in menu 1.1
temperature .
Curve offset
6XSSO\ WHPSHUDWXUH
°C
70
An offset of the curve means that
the supply temperature changes as
much for all the outdoor temperatures, e.g. that a curve offset of +2
steps increases the supply temperature by 5 C at all outdoor temperatures.
2IIVHW KHDWLQJ
FXUYH
Förskjuten
värmekurva
60
50
40
30
10
0
- 10
- 20
- 30
- 40°C
UTETEMPERATUR
2XWGRRU
WHPSHUDWXUH
Chapter 3 | F1155PC – at your service
NIBE™ F1155PC
33