Download Activator and APS Programming System

Transcript
Appendix B: AVI File Description
The first thirteen lines of the file shown above contain header
information. This information is obtained from both the programming
file (.afm or .fus) and the unit being programmed. Each line of the AVI
file header is preceded by a semicolon. The header contains:
• The complete Silicon Signature (read from the device) prior to
programming.
• The ICC standby value of the device before it is programmed. In the
example, the ICC standby of 22 corresponds to a standby of 2.2mA.
• The device “esbin” number, which corresponds to the VPP used
during programming.
The remainder of the AVI file contains information about the
programming sequence. As each fuse is programmed, a new line is
added to the AVI file. The first column of numbers in the AVI file is the
fuse number. A typical RH1280 design requires approximately 15700
fuses to be programmed. The AVI file would contain over 15700 lines,
including header information.
There are 8 additional columns in the AVI file. The 8 columns are listed
in groups of 2, with each group corresponding to a socket on the
Activator 2 (sockets are numbered 1-4). If the Activator 2s is used, the
single socket is always recognized as socket 4.
The first column in a group of 2 contains the final programming
current sensed by the Activator through each fuse as it is programmed.
The programming current is listed in tenths of milliamps and no
decimal point appears in the number. For example, a programming
current listed as 146 corresponds to current of 14.6mA. It is not unusual
for different fuse types to have different programming currents.
The second column in a group of 2 contains the number of VPP pulses
that were required to program a specific fuse. The maximum number
of programming pulses reported in the AVI file is 64464 pulses. There
is an inherent variation in the number of pulses required to program a
fuse depending on the fuse type. You can expect a wide distribution of
VPP pulse counts.
After the array-fuse programming information, test results from the “end
of programming” tests executed by the Activator are stored. If any of these
tests fail, the failing test is indicated in the AVI file.
62