Download Cisco 3750-48TS - Catalyst Switch - Stackable Installation guide

Transcript
Chapter 2
Switch Installation
Installing the Switch
Attaching the RPS Connector Cover
If you are not using an RPS with your switch, use the two Phillips pan-head
screws to attach the RPS connector cover to the back of the switch, as shown in
Figure 2-31.
If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch.
Warning
Figure 2-31
STACK
1
Attaching the RPS Connector Cover on the Catalyst 3750 Switch
DC INP
UTS FOR
REMOTE
POWER
SUPPLY
SPECIF
IED IN
MANUAL
+12v
@8.5a
STACK
2
1
2
3
1
Phillips pan-head screws
2
RPS connector cover
3
86571
CONSOLE
RPS connector
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in Figure 2-32.
Warning
To comply with safety regulations, mount the switches on a wall with the front
panel facing up.
Catalyst 3750 Switch Hardware Installation Guide
2-32
OL-6336-01