Download Binder APT.line FED Technical data
Transcript
Figure 33: Initial sterilization display No sterilization can be started if the CO2 sensor is still plugged-in. You cannot start the sterilization if the operating mode HAND is locked. This is displayed by an error message. If this happens, unlock the operating mode HAND (chap. 7.4). Figure 34: Error message if operating mode HAND is locked or if the CO2 sensor is still plugged-in. • Press “▲”. The upper display toggles from “OFF” to “ON”. • Press “MODE” to start the sterilization cycle. The upper display toggles between the current interior temperature in °C and “StE”. The indication “ - - - “ in the lower display shows that the CO2 sensor is disconnected. Figure 35: Alternating display during sterilization C 150 (E2) 12/2012 page 67/90