Download D-Link DE-816TAC - Hub - Stackable User`s guide
Transcript
D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch Multicast Router Only If this option is enabled and IGMP Snooping is also enabled, the Switch forwards all multicast traffic to a multicast-enabled router only. Otherwise, the Switch will forward all multicast traffic to any IP router. GVRP Status Use this pull-down menu to Enable or Disable GVRP on the Switch. Telnet Status Telnet configuration is Enabled by default. If you do not want to allow configuration of the system through Telnet choose Disabled. Web Status Web-based management is Enabled by default. If you choose to disable this by selecting Disabled, you will lose the ability to configure the system through the web interface as soon as these settings are applied. RMON Status Remote monitoring (RMON) of the Switch is Enabled or Disabled here. Link Aggregation Algorithm The algorithm that the Switch uses to balance the load across the ports that make up the port trunk group is defined by this definition. Choose MAC Source, MAC Destination, MAC Src & Dest, IP Source, IP Destination or IP Src & Dest (See the Link Aggregation section of this manual). Switch 802.1x Enables or disables 802.1x; default is Disabled. Auth Protocol The user may choose between Local and Radius Eap. HOL Prevention Enables or disables HOL (Head of Line) prevention; default is Enabled. Jumbo Frame Enables or disables Jumbo Frame acceptance; default is Disabled. Syslog State Enables or disables Syslog State; default is Disabled. 27