Download Dynamix DW 2 FXO User guide
Transcript
(Used for FXO port with 2-Stage Dialing Only ) Voice file name (MuLaw-mono 8K): Specify the file path and file name to u pload. Please make sure that the file format needs to be G.711U, 8K, 8 bits raw file. (Used for FXO port Only) Flash Time: Flash Time will be send to PSTN line (internal use only) FAX Relay: Enable T.38 Fax Relay or not Input(Encode)Gain: Adjust the volume from PSTN to VOIP (default is 0 db) Output(Decode)Gain: Adjust the volume from VOIP to PSTN (default is 0 db) Dialing Answer Delay Time (sec): When the polarity reversal detection is disabled, Dynamix 2540 will answer the call after this time out without answer supervision. After the DTMF dialing, Dynamix 2540 will send 183 with SDP to enable the voice path for VOIP side. PSTN Answer Ring Count: This ring count is used for called ID detection and 2 stage dialing. If the caller ID is sending during the first ring and second ring, this parameter should be set to greater or equal to If the caller ID is sending before the first ring, this parameter can be set to greater or equal to 1. After the ring count was reached, Dynamix 2540 will answer the call if 2 stage dialing is selected or make the VOIP call out if hot line is selected. CallerID Standard: The detected Caller ID stand for the line. 46