Download Demco KK360 Specifications

Transcript
Folding Ramp
NOTE:
Tow Dolly must be empty and unhooked
to perform any and all of these steps. Do not attempt while tow dolly is loaded or hooked up.
1.
Pull ramp back as far as it will go. Bolt must be past notch before attempting the next step.
2.
Lift ramp until it is past center and resting on it stops.
IMPORTANT:
When taking this tow dolly out of storage it is very important to check all pins and retainers for damage. If damage is found
replace. Do not use damaged pins or retainers. Make sure that
tongue pin and retainer clip is replaced after tongue is folded back
to the forward and locked position. Fold ramps down as far as they
will go and push forward until you hear or see retainer handles snap
into their locked positions. Check to make sure they all fully seated.
Make sure that all pins and locking devices are double checked
before returning this unit to service.
Loading Angle Clearance Guide
NOTE: User’s responsibility for checking clearance
IMPORTANT:
Using this guideline will reduce the chance of the towed
vehicles air dam, or bottom of facia from interfering with
tow dolly platform and or tire stop. “X” must be less
than 3-1/2 x “Y”.
Example: If Y measures 6”
3-1/2 x 6 = 21
X must measure less than 21”
15