Download Siemens ET 77..UC Operating instructions

Transcript
Brief instructions on commissioning ET 200S
2.1 Commissioning on PROFIBUS DP
2.1.2
Install the ET 200S
Proceed as follows
1. Install the DIN rail (35 x 7.5 mm or 15 mm) with a length of at least 210 mm on a solid
surface.
2. Mount the various modules onto the rail, starting on the left side (hang in - swivel down slide to left.) Follow the following sequence:
– Interface module IM151-1 STANDARD
– TM-P15N23-A1 terminal module
– 4 x TM-E15N24-A1 terminal module
– TM-P15N23-A1 terminal module
– 4 x TM-E15N24-A1 terminal module
– Terminating module
3. Set PROFIBUS address 3 on the IM 151-1 STANDARD interface module.
2)) 21
Figure 2-2
*
Setting PROFIBUS address 3
Intended for use with future add ins. Switch must be in OFF position.
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
23