Download Extron electronics MultiMatrix Switcher User guide
Transcript
Ethernet Control This section describes Ethernet connection and Telnet communication to the SMX and includes: • Ethernet Link • Subnetting — A Primer ACT LAN The rear panel Ethernet connector on the SMX can be connected to an Ethernet LAN or WAN. This connection makes SIS control of the SMX possible using a computer connected to the same network. LINK Ethernet Link Ethernet Connection The Ethernet cable can be terminated as a straight-through cable or a crossover cable and must be properly terminated for your application (see figure 63). • Crossover cable — Direct connection between the computer and the SMX. • Patch (straight) cable — Connection of the SMX switcher to an Ethernet LAN. Pins: 12345678 Straight-through Cable Cable Straight-through Pin Pin End 1 Wire Color Wire Color 2 orange1 white-orange End 2 Pin Wire Color white-orange 1 white-green 2 orange 2 green 3 white-green 3 white-orange 4 blue 4 blue 5 5 white-blue 5 white-blue 6 green green 6 green 6 orange 7 white-brown 7 white-brown Crossover Cable 7 white-brown 7 white-brown 8 brown 8 brown 8 brown 3 4 RJ-45 Connector Wire Color Wire Color Pin Wire1Colorwhite-orangePin 1 white-orange 1 2 Insert Twisted Pair Wires Pin (for direct connection to a PC) 2 orange white-orange 3 white-green 3 white-green orange 4 orange blue 2 4 blue 5 white-blue 5 white-blue white-green 3 white-green 6 green 6 green blue 7 4 blue 7 white-brown white-brown 8 brown 5 8 brown white-blue white-blue 1 Side View Crossover Cable (forto connection a switch, hub, or router) (for connection a switch,tohub, or router) End 1 End 1 End 2 End 2 6 (for direct connection to a PC) 8 End 1 brown End 2 Pin Wire Color Pin Wire Color 1 white-orange white-green Figure 63. RJ-45 Connector Pinout 12Tables 2 orange green 3 white-green 3 white-orange 4 blue 4 blue 5 white-blue 5 white-blue 6 green 6 orange To access the SMX via7the white-brown Ethernet port, need the SMX IP address. If the address has 7 you white-brown 8 brown brown and characters, the actual numeric IP been changed to an address comprised8 of words Default Address address can be determined using the ping utility. If the address has not been changed, the factory-specified default is 192.168.254.254. Ping can also be used to test the Ethernet link to the SMX. SMX System MultiMatrix Switcher • Ethernet Control 106