Download Audi RNS-E Install guide

Transcript
Appendix F
Trunk Trim Removal
Rear Cross Panel Trim
•
•
•
•
•
•
Remove trunk light from cross panel trim -1Remove screws -2- (2X)
Remove screws -3- (4X) from fastening rings
-4- on left and right.
Unclip rear cross panel trim -1- upward.
Guide trunk light through opening.
After installing make sure seal is correctly
seated.
Luggage compartment side trim
•
•
•
•
•
•
•
•
Remove luggage compartment
floor covering.
Remove rear cross panel trim.
Remove screws -6- (2X) for
fastening rings -7-.
Unclip clip -3-.
Unfasten clip -4-.
Unclip clip -2-.
Unclip luggage compartment trim
-1- at rear from mounts -5- (3X).
Pull trim forward to disengage
from latch pin.
© 2005, 2006 Lee H.
NSX JR – Audi Symphony I to RNS-E Install Guide – Version 2.1
Appendix