Download Campbell CS475 Specifications
Transcript
CS475, CS476, and CS477 Radar Water Level Sensor • Manufacturer’s Model Number: PS61 (CS475), PS62 (CS476), or PS63 (CS477) • Three Digit Firmware Version Number. • Eight Digit Serial Number of Sensor. TABLE 7-3. Send Identification Command Initial Command Response aI! a13VEGAbbbbPS6233212345678<cr><If> Where (from left to right), a—sensor address 13—SDI-12 compatibility number VEGA = manufacturer’s Name PS62=Manufacturer’s Model Number 3.32Sensor Version Number = Serial Number = 12345678 7.1.4 Cyclic Redundancy Check (CRC) A cyclic redundancy check (CRC) is used to produce and send a small, fixedsize checksum of a larger block of data to the datalogger. This checksum detects errors after transmission or storage. The CRC is computed and added before any transmission or storage. The CRC is also authenticated by the recipient, after the transmission, to confirm that no alterations occurred. CRCs are very good at identifying errors caused by noise in transmission channels. 7.1.4.1 Check CRC for Valid Data The aV! command requests three verification values from the sensor. This command is always followed by the aD0! (Send Data) command. The verification values that will be returned are: 18 • CRC check (error check)—values are 0 (OK) or 1 (failed) • SDI-12 Radar firmware version number • HART Sensor firmware version