Download Armasight T-Series Technical data

Transcript
2. Take off the output lens cap and place it into the storage case.
3. With the nut (B) loosened, position the insert (C) into the adapter’s clamp (A).
4. Screw the adapter into the CO-MINI’s output lens thread.
5. With the nut (B) loosened, slide the CO-MINI, with the adapter, onto the lens of the day scope as far
as it will go.
6. Tighten the nut (B) with a screwdriver.
NOTE:
The second Weaver rail can be installed in place of the removed mount.
A
F
B
E
D
C
Figure 3-10. Scope Mounting System
If the position of the adapter’s clamping nut is undesirable, it can be adjusted by performing the following:
1. Decide on desirable position of the nut and estimate the angle through which the adapter should be
turned CW (see Figure 3-11).
Desirable Position
of the Nut
Nut
Figure 3-11. ESTIMATION OF THE ADAPTER TURNING ANGLE
2. Remove the adapter from the CO-MINI.
3. Using a screwdriver, remove both screws M2×2.5 (F, see Figure 3-10) and then unscrew the ring (E).
23