Download BMW HP4 Technical data
Transcript
Jump-starting The wires leading to the power socket do not have a load-capacity rating adequate for jump-starting the engine. Excessively high current can lead to a cable fire or damage to the vehicle electronics. Do not use the on-board socket to jump-start the engine of the motorcycle. Touching live parts of the ignition system with the engine running can cause electric shock. Do not touch parts of the ignition system when the engine is running. A short-circuit can result if the crocodile clips of the jump leads are accidentally brought into contact with the motorcycle. Use only jump leads fitted with fully insulated crocodile clips at both ends. Jump-starting with a donorbattery voltage higher than 12 V can damage the vehicle electronics. Make sure that the battery of the donor vehicle has a voltage rating of 12 V. When jump-starting the engine, do not disconnect the battery from the on-board electrical system. Remove the front seat ( 54). Run the engine of the donor vehicle during jump-starting. Begin by connecting one end of the red jump lead to the positive terminal of the dis- charged battery and the other end to the positive terminal of the donor battery. Then connect one end of the black jump lead to the negative terminal of the donor battery, and the other end to the negative terminal of the discharged battery. Start the engine of the vehicle with the discharged battery in the usual way; if the engine does not start, wait a few minutes before repeating the attempt in order to protect the starter motor and the donor battery. Allow both engines to idle for a few minutes before disconnecting the jump leads. Disconnect the jump lead from the negative terminals first, then disconnect the second lead from the positive terminals. Installing front seat ( 55). 9 155 Maintenance The latch engages with an audible click. Installing rear seat cover ( 53). with Passenger Bundle OE Installing rear seat ( 54). z