Download protech PROX-1750 Technical data
Transcript
8 Maintenance 112 z board socket can cause damage to the motorcycle's electronics. Always charge a completely drained battery directly at the terminals of the disconnected battery. Charging the battery via the onboard socket is only possible with suitable chargers. Unsuitable chargers can result in damage to the motorcycle electronics. Use BMW chargers with the part numbers 71 60 7 688 864 (220 V) or, as applicable, 71 60 7 688 865 (110 V). If in doubt, charge the disconnected battery directly at the terminals. Charge disconnected battery via onboard socket. The motorcycle's onboard electronics know when the battery is fully charged. The onboard socket is switched off when this happens. Comply with operating instructions of charger. If you are unable to charge the battery via the onboard socket, you may be using a charger that is not compatible with your motorcycle's electronics. In this case, please charge the battery directly at the terminals of the disconnected battery. Charging disconnected battery Charge battery using a suitable charger. Comply with operating instructions of charger. Once the battery is fully charged, disconnect the charger's terminal clips from the battery terminals. In the case of longer periods when the motorcycle is not being used, the battery must be recharged regularly. See the instructions for caring for your battery. Always fully recharge the battery before returning it to use. Removing battery Removing battery compartment cover ( 113). with anti-theft alarm OE Switch off anti-theft alarm if necessary. Switch off ignition.