Download Carlton 3500D Specifications

Transcript
3500D
TROUBLESHOOTING GUIDE
COMPLAINT
CAUSE
CORRECTION
Engine will not start. (See Engine
Manufacturers’ Manual for further
information.)
Hydraulic system loss of power.
•
•
•
•
•
•
Loose ground wire.
Loose hot wire.
Dead battery.
Low oil.
Valve set too low.
Splined pump
coupling worn.
Bad cylinder.
Bad Pump.
Cutterhead speed
adjustment screw
turned wide open.
•
•
•
•
•
•
Clean and tighten.
Clean and tighten.
Recharge or replace.
Refill with correct oil.
Adjust relief valve.
Remove pump coupler.
•
•
•
Belt tension too
loose.
Belt out of alignment.
Engaging or
disengaging belt at
high engine RPM.
Belt keeper too far
from belt.
Belt worn.
Pulley worn.
•
Replace cylinder packing.
Replace Pump.
Screw in speed
adjustment screw to close
bypass. Re-adjust for “no
bounce” cutting.
Tighten.
Swing cylinder loss of power.
•
•
•
Belt Squeal.
•
Belt jumping off.
•
•
•
•
•
Cutter wheel vibration.
Cutter wheel throwing teeth.
Cutter wheel breaking teeth.
•
•
Align Pulleys.
Only engage or disengage
belts at low engine
speeds.
•
Adjust keeper closer to
belt.
Replace belt.
Replace pulley.
Replace missing teeth.
Always replace pockets in
pairs across from each
other.
Install correctly with like
pairs of teeth directly
across from each other.
Replace pocket.
Clean pocket and replace
missing teeth.
Replace cutter wheel.
•
•
•
•
•
•
Tooth missing.
Pocket out of
balance.
•
Improper tooth
arrangement.
•
•
•
Bad pocket.
Dirt in pocket.
•
•
•
Cutter wheel worn
where tooth sits.
Teeth set too far out
of pocket.
•
•
•
Use gauge to set teeth
correctly.
28